Some ancillary components can be operated without the ignition turned on by turning the switch to the auxiliary position. A radio is usually wired through this switch, so that it can be played with the engine off.
Thin wires conduct less easily than thick ones, because there is less room for the electrons to travel through. The energy needed to push current through a resistance is transformed into heat. This can be useful, for example in the very thin filament of a light bulb, which glows white hot.
A headlamp bulb, for example, is designed to have a degree of resistance so that it consumes a certain current to glow normally. But there are at least two headlamps in the circuit. If they were connected in series, electric current would have to go through one headlamp to get to the other.
Printed circuits are plastic sheets on which copper tracks have been printed. Components are plugged directly into the tracks. A few modern cars have flexible printed circuits. The copper tracks are printed in ribbons of flexible plastic, which replace the whole wiring system.