Using the ohmmeter, find the pair of wires that has the highest resistence as measured in ohms. This will give you your common and lowest speed tap. Using each of these two leads in turn, find the pair that gives you the the second-highest resistance. This should provide you the common and second-lowest speed tap and should also allow you to isolate which of the two leads from the first test is the common.
Think of the atoms of magnetic material as an unruly herd of cattle. Running electric current through the material will polarize these atoms, creating the magnetic field. But as I mentioned, this is an unruly herd, so it takes time for the current to bring all those atoms into formation.
The unshielded conductors radiate an electric noise field that couples capacitively with adjacent wiring. Stray capacitance at A & C cause ground currents to flow creating a magnetic noise field that couples inductively with adjacent wiring.
In simple DC and universal motors, the rotor spins inside the stator. The rotor is a coil connected to the electric power supply and the stator is a permanent magnet or electromagnet. Large AC motors (used in things like factory machines) work in a slightly different way: they pass alternating current through opposing pairs of magnets to create a rotating magnetic field, which "induces" (creates) a magnetic field in the motor rotor, causing it to spin around. You can read more about this in our article on AC induction motors. If you take one of these induction motors and "unwrap" it, so the stator is effectively laid out into a long continuous track, the rotor can roll along it in a straight line. This ingenious design is known as a linear motor, and you will find it in such things as factory machines and floating "maglev" (magnetic levitation) railroads.