For wiring a single-phase motor, the most important objective is to distinguish the starting circuit from the main winding. These two circuits are isolated from one another electrically if the lead wires are separarted and not in contact with each other. Initially, the ohmeter can be used to determine which wire belongs to which circuit as well as checking continuity between leads.
Bonding should be by the widest practical means. Wide cable tray is effective when it is made of zinc plated steel and carefully bonded at the ends to control panel and motor frame. Zinc plated sheet steel channel is also effective. The fact that the width is folded into a U shape does not matter. A closing lid helps. Solid steel conduit bonded at both ends is effective. The spiral construction of flexible conduit makes it less attractive for RF shielding because the spiral shape forms an inductor, even with partially shorted turns.
Magnetically soft materials, however, tend to be more expensive. The motor manufacturer must find that proper blend of just enough magnetically soft material to do the work required without putting too big a dent in the customer wallet.
In addition, note that the common lead in this type of motor is usually white or purple. If there are additional leads in the run widing group, continue to use the ohmmeter to test the now-identified common and additional leads. Descending resistance will give you ascending speeds.