Some components must be connected in series. For example, the sender in the fuel tank varies its resistance according to the amount of fuel in the tank, and sends a small electrical current to the fuel gauge.
The sudden surge of high current in a short circuit makes the fuse wire melt, or blow, breaking the circuit. When this happens, see if there is a short circuit or a disconnection, then install a new fuse of the correct amperage rating (See Checking
For wiring a single-phase motor, the most important objective is to distinguish the starting circuit from the main winding. These two circuits are isolated from one another electrically if the lead wires are separarted and not in contact with each other. Initially, the ohmeter can
Where wires run side-by-side they are bound together in a bundle, in a plastic or fabric sheath, to keep them tidy and less difficult to fit. This bundle of wires stretches over the length of the car, with single wires or small groups of wires
The charging circuit consists of your battery, ignition switch, rectifier/regulator, and stator. When your engine is operating, your stator produces an alternating current by means of electromagnetic induction. This alternating current is fed to your rectifier/regulator by two wires. These two stator wires connect to
Shield drain wire must be spliced only to mating shield drain wires and not grounded at the junction box. Feedback shields must be passed through pin for pin. Separate junction boxes for power and feedback are required.
Suppose you take a length of ordinary wire, make it into a big loop, and lay it between the poles of a powerful, permanent horseshoe magnet. Now if you connect the two ends of the wire to a battery, the wire will jump up briefly.
Depending on the fuse design, it is sometimes possible to tell whether it has blown by holding it up against a light; a break in the wire inside may be visible. Another clue is blackening of the glass cover. If there is no visible sign,
Since active devices usually supply signal energy to an electronic circuit, and since energy can only be transformed and not created, a source of energy is needed when active devices are present. This energy is usually obtained from batteries or through rectification of sinusoidal voltages
The two components are connected in series so that the varying resistance in the sender will affect the position of the needle on the gauge.